Product description
The hand-and-a-half sword had a size between a one-handed sword and a two-handed sword. The grip was somewhat larger than the grip of a one-handed sword so that the soldier could put an extra hand on the grip for hard blows and put more force behind the blow.
This hand-and-a-half sword is made by Cold Steel. It weighs just 1372 g and its length is 114 cm. The blade has a length of approx. 98 cm, a thickness of 5,1 mm and is razor sharp! The grip is made of hardwood and covered with black leather for extra user comfort. The blade is made of 1055 carbon steel.
Product details:
Length: 115.6 cm;
Blade length: 85.10 cm;
Grip length: 30.5 cm;
Blade width at guard: 5.1 cm;
Weight: 1389 g;
Steel type: 1056 carbon steel, hardness 52-54 HRC;
Edge: sharp;
Tang construction: Full tang construction;
Pommel: Screwed;
Grip wrapping: Wood, Leather;
Based on a historic original: Yes;
Transport weight (in gram): 3000 *
This item cannot be shipped to countries outside the EU due to its length.
This item is produced in limited quantities only. This means that every piece is unique. Sizes & finish may vary lightly from piece to piece.
We do not sell this product to customers under the age of 18. Click here for more information on the European arms acts.
We ask for a one-off age verification when purchasing sharp objects
Click here for more information.
The parcel of this item will be labelled: “Warning, sharp content. Please only deliver to adults (18+).”
Packaged with 100% recycled material
When packaging this item, we exclusively use 100% recycled plastic and recycled paper/cardboard from FSC certified forests. We reuse a large part of the material directly without the intervention of a recycling process.
Recycle the material by separating your waste:
1. Cardboard: separate or reuse your paper.
2. Plastic cushions, clothing bags and plastic tape: separate or reuse your plastic. If possible, pierce the cushions with a volume reduction needle.
3. Paper packaging for jewelry and small items: these have a plastic inner layer. Remove these, then separate your paper and plastic.
